Schneider Electric Conext System Control Panel (SCP)

Note: a Xantrex XW+ or SW Inverter must be part of your system for the System Control Panel to function.

Schneider Electric
Conext System Control Panel (for XW+ and SW Series)

The Conext System Control Panel (SCP) eliminates the need for separate control panels for each device and gives a single point of control to set up and monitor the entire Conext inverter charger system, including Conext MPPT Solar Charge Controllers. Featuring a graphical backlit liquid crystal display, the SCP selectively displays configuration, status and diagnostic information for all devices connected to the Xanbus network.

Parts Included: 1 remote head; 1 network terminal; 1 Cat5 cable; 1 mounting plate; 1 mounting bracket; 4 #8 screws; 2 #6 screws

FEATURES:

Monitor and configure Conext XW+, SW, MPPT 60 150, MPPT 80 600, AGS, Battery Monitor

Multiple SCP can be used on the same Xanbus network

Compatible with Conext ComBox

Access and troubleshoot Xanbus enabled devices on the network from one location

Surface mount or panel mount on wall

RJ45 connections for Xanbus network cables

Internal clock—keeps time for the entire system

Audible alarm—if enabled, alerts you when a fault condition arises

Low power consumption—automatically turns off the backlight after a period of inactivity

Non-volatile memory—preserves SCP settings if network power is interrupted or network communication is disrupted

5 Year Warranty

ELECTRICAL /MECHANICAL CHARACTERISTICS:

SPECIFICATIONS
Nominal Voltage	15 VDC
Min Operating Network Voltage	14.25 VDC
Max Operating Network Voltage	15.75 VDC
Max Operating Current at Nominal Voltage	200 mA
IP rating / location	IP20/indoor only
Operating Temperature Range	-20 to 50ºC (-4ºF to 122ºF)
Network	Protocol: Xanbus / Connectors: RJ45
Safety	CSA 107.1, UL 458 4th Ed