We are no longer offering this product.
The below information is presented for informational purposes only. You may also find similar items in the category.- FEATURED PRODUCTS
- Solar Panels
- Solar Power Systems
- Productos Solares en Puerto Rico
- Charge Controllers
- Inverters
- Deep Cycle Batteries
- Solar Panel Mounts
- MORE PRODUCTS
- Cables & Wiring
- Enclosures, Electrical & Safety
- Inverter Power Panels & PreWired Systems
- Meters, Communications & Site Analysis
- Portable Power Systems
- Solar Water Pumps
- Voltage Converters
- Wind Turbines
- Books & Education
- * Clearance Sale *
- Hot Deals
- Open Box & Refurb Deals
Wi-Fi Solar Charge & Load Controller, PT 12-10-WI
Item code | Brand name | Model number | Amps |
SORPT12-10-WI | Solar Converters | PT 12-10-WI | 10A |
Installed by the US Military, this unique solar charge and load controller is specially desig
Solar Converters Inc.
Solar Charge and Load Controller
for POE (Power Over Internet) Systems
PT 12-10-WI
This unit is designed to charge a battery from a 12 V nominal solar panel. It outputs 5 V, 48 V and 12 V DC to power a typical POE (Power Over Ethernet) system.
These new controllers from Solar Converters are ideal for use in small remote telecom/ wireless products with universal go anywhere battery charging (90 - 267 V / 50 - 60 hz AC, car battery, truck battery or solar panel) and produce multiple UPS outputs consistent with computer / telecom/ wireless systems 5 V, 12 V and 48 V UPS outputs. Other voltages are readily obtainable.
Features
- Nominal Maximum power point tracking to optimize output power
- No User load overvoltage, regulates output voltage to float voltage even with no battery connected
- High Efficiency: >94% over 20% charging load
- No need for external blocking diode
- Transient protected - input and output
- Temperature range: -40C to +60C
- Internal 25-amp battery fuse
- 1 Year Limited Warranty
Solar Panel / Input Requirements | |
Input Voltage | 0 -30 DC volts PV Array, approx. 15.5 nominal operating |
Max. Input Current | 8 DC amps nominal |
Battery Charger Output | |
Output Voltage | factory set 13.8 Vdc +/- 0.2 V |
Output Current | 10 amps continuous (provided sufficient solar power) |
Low Voltage Disconnect | Off @ 11 V, On at 12 V dc |
DC Outputs | |
5V Output Voltage: |
5.3 Vdc |
Current: | 5 amps |
Connection: | 2.5 mm power Plug = White end |
48V Output Voltage: |
48 V DC +/- 0.3 V |
Current: | 0.6 A DC |
Connection: | 2.5 mm power Plug = Blue end = Polarity Controlled by internal B Toggle 2.5 mm power Plug = Red end = Polarity Controlled by internal A Toggle |
* Note: | Internal Toggle Switches are used to determine if the output 48 V output is to operate a CISCO POE or a Standard POE Device. Essentially the polarity of the Power Plug is reversed |
12V Output Voltage: |
12 V DC +/- 0.3 V |
Current: | 2 A DC |
Connection: | Internal Terminal Block |