| Subject | Started by | Replies  |
|---|---|---|
Wind Generator Made In USA?I purchased and installed a Soutwest Windpower Air-X 400w 24vdc wind generator a few years ago, as part of a solar/wind hybrid s... |
Travis M | 18 |
PMA wild voltage output.OK I'm a newbie to wind power and have a basic question. Looking at the Windblue PMA's it states that on the 520 model... |
Philip Giammatteo | 8 |
maximum power output while charging batteryRecently I have constructed a permanent magnet generator that generates 368W at 400 RPM at no load and when loaded with
batt... |
Simon Silwal | 8 |
Voltmeter placementI have just completed a DIY Wind Gen. I am double checking myself but if I wanted to check the output voltage I would place my v... |
Max Schulte | 3 |
battery charging through PMGI have collected some data from my PMG while charging a 12v battery and I am not sure with them. The problem is battery charges ... |
Simon Silwal | 3 |
motor driven battery charger and controlleri have a system an outback vfx 2430 invert. a fm 80 ch.contr. 4 torjan t105 225ah batt.a mate don have the panell yet but have a... |
Donald Keith | 2 |
600 Watt Sunforce wind turbineHello,
I am new to this forum, but have been living off-grid for many years. A short time ago, I added a Sunforce win... |
David Cellini | 2 |
Small Hydro projectI am currently working on a small hydro generator for my boat. I have a 760w 48v DC perm mag motor with a 10/1 reduction. I am a... |
Bob Mcdowell | 2 |
Two turbines, one battery bank.I have completed a successful test run on my DIY wind turbine, ave 200 watts, running an ac output to a rectifier next to my 12 ... |
Philip Giammatteo | 1 |
Wanted: Jacobs bladesI am rehabbing a 110 v. 2500 watt Jacobs wind turbine, with sitka spruce 6 ft blades. One of the blades is weathered and h... |
David Oien | 0 |
Air X repair?Hi
Can anyone tell me if the air breeze, air 30/40 stator and electronic controller can be fitted into an early Air X turbi... |
Steve Jones | 0 |
Disclaimer and Disclosure
The Alternative Energy Store, Inc reserves the right, within its sole discretion, to refuse or delete any posting or portion thereof, or terminate or block the access to this forum.
The opinions and statements posted on this forum are the opinions and statements of the person posting same, and do not constitute the opinion or act of the Alternative Energy Store, Inc (AltE). The Alternative Energy Store, Inc does not endorse or subscribe to any particular posting. No posting shall be construed as the act or opinion of the Alternative Energy Store, Inc.
