Rocco Cliffe's posts

It's actually a 12 volt wind generator rated for 600 watts but also a  90 volt pm generator. Thats what the guy said who I bought it from.

I just want to make sure, the generator is a 90 vdc and the guy says it's 600 watts, can you tell me what the amps are from that? thanks

Ah... I didn't do the math, you are right, the c35 is only good for 35 amps, I guess I'll start looking for a c60 and sell my c35 on ebay. Thanks

So basically all I need is the 1000 watt air dump resistor, I only need one not two correct?

I'm looking for some information about the feature on the xantrex c35 model, it's called load diversion. I purchased a 600 watt wind generator and the Xantrex c35 and want to ask about the load diversion, I know when the batteries get fully charged I need to divert the energy to a separate heater or something similar, so if I'm using a 600 watt wind generator I must find something that is over 600 watts like a heater, but my problem is where do I find a heater that is 600 watts and 12 volts at the same time, any heater that I've run into that is 12 volts is at best 150 watts. I was thinking, can I not run the two wires out of the xantrex load diversion output to a 1000 watt invertor and then plug in an 800 watt electric ceramic heater to the invertor?