Things To Consider When Using A High Voltage MPPT Charge Controller

Things To Consider When Using A High Voltage MPPT Charge Controller

While the idea of using a high input voltage charge controller is intriguing, there are some things to consider. The benefit of using a high voltage charge controller is the ability to have one long series string of solar panels wired together, or fewer strings in a system. This reduces the number of cables, reduces wire size and voltage drop issues, and reduces the number of breakers in the system for easier wiring and faster installation.

a high voltage solar MPPT charge controller

A high voltage solar MPPT charge controller

It is certainly nice to be able to series a bunch of modules together, but keep in mind that the balance of system components that are required will change from the norm. Once the temperature corrected open circuit voltage of the module string exceeds 150VDC we need to make sure that the components between the PV and controller are also rated for that voltage. Most of the DC rated breakers are rated for 150VDC which is fine for most of the controllers that have a 150VDC max input, but with higher voltage units now available these breakers are not always viable. There are some manufacturers out there that are now making 300VDC breakers to accommodate their high voltage charge controller units. These breakers are actually a combination of two 150VDC breakers, so this means that the size is equal to two breakers. So when choosing a combiner box or enclosure, it is important to keep in mind that the 300VDC breaker will be taking up two breaker spaces. One manufacturer is also manufacturing enclosures specifically for their high voltage breakers. When using a controller that has a 600VDC input, the enclosure options also get a little more expensive. One option is to use a combiner box with touch safe fuse holders and 600VDC fuses, but since the code requires both overcurrent protection and a means of disconnect, a 600VDC rated disconnect would also be required. If you are not combining any strings you could use a fused 600VDC disconnect.

So before you jump into a high voltage unit remember not to use the good …8216;ol standard breakers that you are accustomed to. High voltage breakers and enclosures are a must in a system with a high voltage charge controller.

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.