Dankoff Slowpump 1304-12VDC SURFACE PUMP

Dankoff
SLOWPUMP® SOLAR PUMP
MODELS: 1300,1400,2500,2600

Use Solar-Electric Power to provide 200-2,600 Gallons per Day (750-10,000 ltrs.) from shallow water sources. Slowpump can push water as high as 560 vertical feet (170m).

Solar Slowpump was the world's first commercially available low power solar pump. It was developed by Windy Dankoff in 1983, in response to those who said "that's impossible." Thousands of Slowpumps have been installed worldwide by ranchers, homeowners, missionaries, health workers, government agencies, etc. Some of our oldest Slowpumps are still in daily service.

Slowpump is not submersible, but can draw water from shallow wells, springs, cisterns, tanks, ponds, rivers, and streams, and push it as high as 560 vertical feet and through miles (kilometers) of pipeline. Slow pumping minimizes the size and cost of the solar array, wire and piping.

Slowpump is less expensive than sub-mersible DC pumps, and made in a much wider range of sizes. Wearing parts typically last 5 to 10 years. Overall life expectancy is 15-20 years.

"The Slowpump #2507-24V is supplying water for a work camp on the outer island of Onotoa. It's supplying water for 60 people. The well is one half mile 800m away from the camp." -- B.C., Ministry of Works and Energy, Kiribati, South Pacific

"I have been very happy with the 1308 Solar Slowpump!...We are using it in a 5 meter deep hand dug well in a valley, and pumping 200 meters distant and 50 meters vertically." ---
Dr. D.L., World Missions, Cameroon, W. Africa

"These pumps work great.... Even during low light levels when the motor is turning slowly, a small amount of water can be pumped.... The manual is easy to read. Windy's troubleshooting section is excellent....Not only have these pumps stood the test of time, but small changes have made them even better." --- B. Schultze -product review in Home Power Magazine #42

Construction & Features

• Rotary vane mechanism (positive displacement) made of forged brass, carbon-graphite and stainless steel
  
• NSF® approved for drinking water
  
• Handles sea water, dissolved minerals
  
• Survives most freezes
  
• Permanent magnet, DC motor
  
• AC models use a low-surge PM motor that greatly reduces starting surges, inverter and wire size requirements
  
• Installation and Service Manual is highly detailed and illustrated

Performance Charts

1300 & 2500 series 1/5 HP * PV Direct or Battery 12VDC, 24VDC, 48VDC, 115VAC
Model Numbers (Add -12 or -24 or -48 to indicate voltage)

1400 & 2600 series 1/2 HP * PV Direct or Battery 24VDC, 48VDC, 115VAC
Model Numbers (Add -24 or -48 to indicate voltage)

Reading the Performance Charts

1. Identify Total Lift for your application = Vertical Distance from surface of the water source to the pipe outlet or top of storage tank, plus any pipe friction loss
2. Choose SlowPump model based on desired output (GPM) and/or required solar power (PV Watts) at the Total Lift
3. Select the desired pump Voltage from the available options for that model

** Actual performance may vary +/- 10% from specifications - based on PV-Direct voltage of 15, 30, or 60 (the standard Vmp of 12V, 24V, and 48V configurations at STC). For battery-based applications, subtract 20% from Flow and Watts.

** PV Watts column is the recommended power after taking the Watts required at the Pump and upsizing by 25% for de-ration, then rounding to the nearest increment of 5.

Suction Capacity

• 20 vertical feet (6 m) at sea level -- subtract 1 ft. for every 1000 ft. altitude (1 m for every 1000 m). Pump should be mounted as close to the water source as possible to reduce suction lift.

Filtration Requirement

• These pumps CANNOT tolerate dirt. Water MUST be filtered clear. Failure to use a Dankoff Solar Pumps filter unit, or use of a filtration unit other than Dankoff, will void the warranty on the pump. If water is very dirty, improve the source or consider using Dankoff's dirt-tolerant pump models (SolarForce, SunCentric, or Solaram).

PV-Direct (non-battery) Requirements

• The rated power of the PV array must meet the Watts listed in PV Watts column in chart above.
• A Linear Current Booster (controller) is required to function in varying light conditions (12V/24V: 5Amp, 8Amp, 15Amp, 48V: 10Amp)
• Solar Tracker (optional) to increase daily yield (40-55% in summer)

Accessories

• Intake Strainer/Foot Valve with fine monel metal screen, stops course debris
• Inline 10 micron Filter (10-inch) uses standard drinking water cartridges
• Intake Filter/Foot Valve (30-inch) replaces Intake Strainer and Inline Filter (10 micron) with a single unit, best for lowering into a shallow well
• Spare Filter Cartridges (5 or 10 micron spun fiber)
• Dry Run Switch prevents battery drain and pump damage if water source
  runs dry
• Linear Current Boosters (LCB) for PV-Direct (12V/24V: 5Amp, 8Amp, 15Amp, 48V: 10Amp)

Fittings

• 1300/1400 Series: 1/2 inch female pipe thread
• 2500/2600 Series: 3/4 inch male thread

Dimensions

• 1300/2500 Series: 5.75 x 17.4 inches (14.6 x 44.1 cm), 13 lbs (5.9kg)
• 1400/2600 Series: 6.5 x 18.75 inches (16.51 x 47.63 cm), 25 lbs (1400 series), 29 lbs (2600 series)

Warranty

• 1 year against defects in materials and workmanship. Failure to use a Dankoff filter unit will void warranty.

*formerly 13xx and 25xx

**formerly 29xx