- 2019 Solar Installer Conference
- FEATURED PRODUCTS
- Solar Panels
- Solar Power Systems
- Battery Backup Solar Power Systems
- Puerto Rico Solar Products
- Charge Controllers
- Deep Cycle Batteries
- MORE PRODUCTS
- Cables & Wiring
- Enclosures, Electrical & Safety
- Heat Pump Water Heaters
- Inverter Power Panels
- Meters, Communications & Site Analysis
- Portable Power Systems
- Refrigerators & Freezers
- Solar Panel Mounts
- Solar Water Pumps
- Voltage Converters
- Wind Turbines
- * Clearance Sale *
Sun Pumps Submersible Sds-D-128 (12-30 Volts)
|Item code||Brand name||Model number|
SDS Series Submersible Pumps
They operate on 12 to 30 volts of DC current that may be supplied from a variety of independent power sources including solar panels, wind generators, batteries or any combination of the three. Power requirements can be as little as 35 watts.
Constructed of marine grade bronze and 304 stainless steel, these pumps are the highest quality submersible pumps in their class.
SunPumps SDS series pumps can be installed below the water level in a pond, river or cistern, or installed by hand into a ground water well. They can be used to fill an open tank or in a pressurized water delivery system. Simplicity is the key feature of the SDS series pumps. They are easy to install, require very little maintenance and are repairable.
SunPumps SDS-D series (Duplex) submersible pumps are one of the highest quality, low votage DC pumps on the market. They were the first diaphragm submersible introduced to the solar industry in 1988 and have an excellent performance record.
The SDS series pumps are easy to install by hand without any special equipment. The pump includes a double shrink splice kit and a 1/2" brass discharge fitting.
Description of the SDS-D-128 Submersible Pump
Note: The depth capabilities of the SDS-D-128 has been expanded from 115 feet to 230 feet starting in June 2005. It now has the same depth rating as our SDS-D-228 but with a higher flow rate.
Each SDS Series pump is designed to work with a SunPumps controller. The SunPumps controller options are high quality, micro-processor based DC power converters designed to act as the interface between a DC powered pump and any DC power source. The pump controller:
* Choose either a PV Direct controller or a battery based option from our add-ons section above.
SDS-D-128 Power Requirements
This pump appears to be working perfectly. I purchased the shroud to assist in lengthening its life span. My solar person also noticed that the previous well-pump people had put in 3/4 dia pipe instead of 1/2, so that has been replaced. A product works only as good as the basic installation. rn...
Read the full review