SHOP ALL PRODUCTS
- FEATURED PRODUCTS
- Solar Panels
- Solar Power Systems
- Productos Solares en Puerto Rico
- Charge Controllers
- Inverters
- Deep Cycle Batteries
- Solar Panel Mounts
- MORE PRODUCTS
- Cables & Wiring
- Enclosures, Electrical & Safety
- Heat Pump Water Heaters
- Inverter Power Panels & PreWired Systems
- Meters, Communications & Site Analysis
- Portable Power Systems
- Solar Water Pumps
- Voltage Converters
- Wind Turbines
- Books & Education
- * Clearance Sale *
- Hot Deals
- Open Box & Refurb Deals
S-5-PV Kit 2.0 MidGrab Midclamp Kit UL
S-5-PV Kit 2.0 EdgeGrab Endclamp UL
Model:
S-5-PV Kit 2.0 (MidGrab 2.0)
S-5-PV Kit 2.0 Edge (EdgeGrab 2.0)
Select model:Item code | Brand name | Model number |
S5-PVKIT2.0 | S-5! | S-5-PV Kit 2.0 |
Item code | Brand name | Model number |
S5-PVKITEDGE2.0 | S-5! | S-5-PV Kit 2.0 Edge |
S-5!
S-5-PV Kit 2.0
UL Listed
New from the metal roof experts: The S-5 PV Kit 2.0 is designed to save you time and money!S-5! now introduces a new and improved PV Kit, boasting lower installation time and cost for PV flush-mounting. The kit comes pre-assembled with MidGrab midclamp or EdgeGrab endclamp for easier and more efficient installation. A single tool drives the top bolt, eliminating several installation steps. The PV Kit 2.0 features more aggressive bonding teeth for better grounding. Fewer lugs/ground wires required.
The concept of combining photovoltaic arrays with standing seam metal roofing is growing, and for good reasons. A standing seam metal roof has a life expectancy consistent with that of framed PV modules. A 30-year power source on a 40-year roof, along with zero-penetration technology creates the most sustainable roof system available with alternative power generation, all without compromising the roof's warranty!
The S-5-PV Kit 2.0 also features a stronger stainless steel mounting disk with twelve nodes designed to ensure the module-to-module conductivity of anodized aluminum module frames. This means the module is simply anchored with the kit, and is automatically bonded. No lugs or wire required except to connect one string of modules to another and to ground the system.
The PV Kits can be used with the following attachment clamps (NOT included - sold separately) that mount to the solar module: S-5! Mini Clamps, S-5! CorruBrackets and S-5! VersaBrackets.
Features
- Pre-assembled components save time and money
- Compatible with most common metal roofing materials, including aluminum, steel, copper, zinc and stainless
- Versatile: supports module frame sizes 33 - 46 mm
- A single tool drives the top bolt, eliminating several installation steps
- Installs with module, reducing lay-out time
- All non-corrosive aluminum and stainless steel
- Single-piece EdgeGrab endclamp kit (sold separately) saves on installation time
- MidGrab, however, can also be used as an edge condition if desired
- Added slots for wire tie-off
- Low profile hardware provides flush, clean finish
- 1″ gap between modules, allowing load reduction per ASCE-7
- UL 2703 Listed
Add-Ons
Add-Ons
Add-Ons
Add-Ons