877-878-4060

We are no longer offering this product.

The below information is presented for informational purposes only. You may also find similar items in the category.
SHOP ALL PRODUCTS
V

Solar Converters Ppt 48-20A, 48V Linear Current Booster

Solar Converters Ppt 48-20A, 48V Linear Current Booster
Solar Converters Ppt 48-20A, 48V Linear Current Booster
 
Item code Brand name Model number
SORPPT48-20 Solar Converters PPT 48-20

Solar Converters Inc - PPT 48-20
48V @ 20 Amp Linear Current Booster
Pump Driver

Solar Converters Inc
PPT 48-20
PPT 48-20  Linear Current Booster

Application

Used to control and power a DC motor from a solar panel. The unit prevents stalling of the motor under less than full sun condition. The power of the sun is transformed to the motor running conditions so as the sun goes down the motor slows down instead of stalling. Conversely, or as the sun comes up the motor starts running much earlier instead of staying stalled for hours when it could be running. This translates into more running time of the motor where it spends a lot of time working instead of stalled doing no work.

Features

  • Voltage Limited Output to 60 V
  • Greatly increases water flow, even under reduced sunlight conditions (over 40% likely)
  • Transient Protected on the input and output
  • Float/Dry Switch input for on/off control
  • Pump Protection Features - Well Dry, Low Sun, Current Limited, Temperature Limited
  • LED display of pump performance
  • Interface for Optional Digital meter MT-3
  • Ultra High Efficiency >94 %
  • Rainproof NEMA 3R enclosure

Electrical Specifications

Nominal Voltage (V) 48
Nominal PV Input (V) 48
Maximum PV Input (V) 90
Maximum Output Voltage (V)** 60
Maximum Output (A) 20
Maximum Output (A)
short term - 10 sec
40
Efficiency >95%

** Special units have a suffix of M XX after the part number. The float value of the charge controller is XX. For example PPT 48- 20 M12 will power a 12 V motor from a nominal 48 V solar panel. Note that the motor current increase by the ratio of approx. 60/12. Thus a 1 amp 48 V nominal solar panel will power the motor at 5 Amps.

User Controls

Pump On/Off, Reset

LED Display

Start Delay, Dry Well??, Dry Well delay, Float Switch Activated, Current Limit, Pump Voltage / Power, Over Temperature Controlled

Protections

  • Dry Well:
    • Unit senses when the well is dry by sensing very low pump current - no load on pump. If the condition exist for three seconds, the output is disabled for 20 minutes to allow the well to refill. Reset clears this condition.
  • Low Sun:
    • Unit senses when the sun is producing too little power to reliably run the motor (1/4 power point) and will shut off for 3 minutes to prevent unnecessary brush wear.
  • Temperature Limited:
    • The unit will reduce motor power if the unit is running too hot to maintain a constant unit temperature and prevent unit failure form overtemperature.
  • Current Limited:
    • The unit will current limit its output to protect the unit and the load from jammed motor/ low resistance operation. An external fuse rated for the motor is recommended.

Mechanical Specifications

  • Weight: approx. 11 lbs.
  • Size: 10" X 8" X 4" nominal, NEMA 3R (rainproof) enclosure
  • Operating Temperature: -40 to 70 deg. C
  • Humidity: NEMA 3R Enclosure

Connections

  • Power: PV and Load
  • #6 AWG AWG Eurostyle Terminal Strip
  • Voltage Select, Reset, Delay Override, Float/Dry Switch Control: NO and NC styles supported
  • Signal: #16 AWG Eurostyle Terminal Strip

Application Notes

  1. This Pump Power Tracker(TM) is quite capable of putting out over 60 amps into a stalled load even from a single 30 watt 4.5 amp panel. It is recommended that a fuse or overtemperature switch matched to your pump motor be incorporated in the system to protect your pump or motor. The units internal fuse will protect the unit.
  2. Float switch operation draws microamps of current, i.e. small wire gauge, allowing long distance runs between float switches / holding tanks, and PV / pump driver without the need to string long lines of heavy gauge wire.
  3. Unit is a true 20 amp unit, all necessary derating already accounted for.
  4. As with all electronics, it is recommended the unit not be mounted in direct sunshine.
  5. Solar panel or energy limited input only.

Note: In the interest of continuous product improvement, specifications subject to change without notice.

Order Model No:

PPT 48-20
PPT 48-20 MXX for different motor voltage where XX is the max. motor voltage

Special Shipping Note:
All Solar Converter Products are behind in production. These items are usually shipped directly from the manufacturer in Canada. They cannot be shipped by any expedited methods such as UPS Blue or Red. They will generally be shipped via Canadian Express Mail which avoids import brokerage fees of $50-$60. Lead time on these products may be up to 4-6 weeks depending on their production. This is true of all Solar Converters products with the exception of the battery desulphator (item code SORBD-2) that we stock in our warehouse. If you want Solar Converters products to be shipped by normal Canadian Post, but would prefer to have the rest of your order to be shipped by a faster method, please write this information in your order's notes during checkout.

Solar Converters Inc


Click here for BBB Business Review ASE NESEA Member
Paypal Visa MasterCard Amex Discover
McAfee SECURE sites help keep you safe from identity theft, credit card fraud, spyware, spam, viruses and online scams