Best way to connect Air-X wire leads

1 Posts
Aug 19, 2006 01:33 pm
Best way to connect Air-X wire leads

Hi Gang,

Excited to try out my new Air-X 400. Was wondering what is the best way for connecting the raw wire leads coming off the turbine to the length of wire that runs down the pole.

This is for a temporary installation so what would be cool would be some sort of dis-connetcable thingy.

Anyone have any ideas?

Thanks!
 
13 Posts
Sep 7, 2006 09:24 pm
Re: Best way to connect Air-X wire leads

Air-x reccommends 1 1/2 inch schedule 40 (not very expensive and works very well)piping.It fits very securely to the base of the Air-x. There is enough room within the pipe to use wire nuts, The wires run from the base directly into the pipe. if you stagger the length of the three wires (trim them) so they do not end up with the wire nuts all next to each other. That is what I did, pull them into the pipe carefully after wrapping in electrical tape and you even get a slight amount of cable relief....
Great unit....quiet too....
« Last Edit: Sep 16, 2006 10:11 pm by Craig Flanders »
 

Disclaimer and Disclosure

The Alternative Energy Store, Inc reserves the right, within its sole discretion, to refuse or delete any posting or portion thereof, or terminate or block the access to this forum.

The opinions and statements posted on this forum are the opinions and statements of the person posting same, and do not constitute the opinion or act of the Alternative Energy Store, Inc (AltE). The Alternative Energy Store, Inc does not endorse or subscribe to any particular posting. No posting shall be construed as the act or opinion of the Alternative Energy Store, Inc.

Click here for BBB Business Review

McAfee SECURE sites help keep you safe from identity theft, credit card fraud, spyware, spam, viruses and online scams
Desktop Website | Mobile Website

Share

Click on an icon to share! If you don't see the method you want, hover over the orange "+".

Feedback

What can we do to help you?

Please enter a summary
Sorry, the copyright must be in the template.
Please notify this forum's administrator that this site is using an ILLEGAL copy of SMF!
Copyright removed!!