1Tu30 100' Tilt Up Tower for Xl1

Bergey Wind Power
BWC Tilt.Tower for the XL.1 Wind Turbine

The BWC Tilt.Tower is the most complete, out-of-the-box, user-friendly tower system for a small wind turbine on the market today.  It is available exclusively for use with the 1 kW BWC XL.1 wind turbine (i.e., we do not sell it for use with other brands of wind turbines). The Tilt.Tower is a guyed tilting tower that allows all work to be done at ground level and it is available in heights from 18.3 m (60 ft) to 30.5 m (100 ft).  The Tilt.Tower is ruggedly built and comes with the longest warranty (5 years) in the industry. 

The Tilt.Tower is the factory recommended tower for the Bergey XL.1 tower because it combines cost-effectiveness and ease of installation. Over the long-term the Tilt.Tower will also reduce "total costs of ownership" by making it easier for owners to inspect, provide preventive maintenance (particularly in corrosive environments), and perform repairs to the XL.1 wind turbine.

The Tilt.Tower kit includes all of the components and fasteners required to assemble and ground the tower. The tower can be installed without concrete work in areas with good soil strength and no rocks (that would impede the screw-in guy-wire anchors). Proper grounding (or "earthing") is an important element in protecting the system from lightning damage.

  The Tilt.Tower is available in three heights:

• 18.3 meters (60 ft)
• 24.4 meters (84 ft)
• 30.5 meters (100 ft)

These towers have tower sections ~ 3 meter (10 ft) long and they ship via motor freight.  The Installation Manual for this tower is available in the Datasheets section at the top of the page.

As shown in the figure above, the tower is guyed in four directions. The tower is guyed at vertical intervals of approximately 20 ft (6 meters). The Tilt.Tower is best installed on level ground, but can be installed on slopes or uneven terrain provided that the base and the anchors on the tilt-axis can be kept fairly level.

After assembly of the tower, wind turbine, and tower wiring on the ground, the tower and turbine are tilted-up to the vertical position using a winch (optional) or a vehicle. A winch is preferred because of the greater control they afford. The towers are provided with a lever arm, called a gin-pole, which runs from the base to one of the guy anchors. The gin-pole converts the pulling force on the pull-up rope or cable into a lifting force on the turbine and tower. The figure below shows the major components of the BWC Tilt.Tower.

Specifications

Wind Turbine:  BWC XL.1 only
Max. Design Wind Speed:  54 m/s (120 mph)
Type:  Tubular tilt-up with guy wires
Section Diameter:  114 mm (4.5")
Material:  Galvanized steel