877-878-4060

We are no longer offering this product.

The below information is presented for informational purposes only. You may also find similar items in the category.
SHOP ALL PRODUCTS
V

Solar Converters 10A, 12/24V Linear Current Boost for Solar Pumps

Solar Converters 10A, 12/24V Linear Current Boost for Solar Pumps
Solar Converters 10A, 12/24V Linear Current Boost for Solar Pumps
 
Item code Brand name Model number
SORPPT12/24-10 Solar Converters PPT 12/24-10

Solar Converters Inc - PPT 12/24-10
12V/24V @ 10 Amps, Dual Voltage
Linear Current Booster / Pump Driver

Solar Converters Inc
PPT 12/24-10
PPT 12/24-10  Linear Current Booster

Application

Used to control and power a DC motor from a solar panel. The unit prevents stalling of the motor under less than full sun condition. The power of the sun is transformed to the motor running conditions so as the sun goes down the motor slows down instead of stalling. Conversely, or as the sun comes up the motor starts running much earlier instead of staying stalled for hours when it could be running. This translates into more running time of the motor where it spends a lot of time working instead of stalled doing no work.

Features

  • Voltage Limited Output
  • Internal Fuse- 15 amp automotive style fuse
  • Greatly increases water flow, even under reduced sunlight conditions (over 40% likely)
  • Transient Protected on the input and output
  • Float Switch input for on/off control
  • Single Unit Switchable 12 V or 24 V
  • Ultra High Efficiency >94 %

Electrical Specifications

Nominal Voltage (V) 12 / 24
Nominal PV Input (V) 12 / 24
Maximum PV Input (V) 60
Maximum Output Voltage (V) 15 / 30
Maximum Output (A) 10
Maximum Output (A)
short term - 10 sec
15
Efficiency >94%

** Special units have a suffix of M XX after the part number. The maximum output voltage of the pump driver is XX. For example PT 12/24 - 10 M6 will power a 6 V motor from a nominal 12 V solar panel. Note that the motor current increase by the ratio of approx. 15/6. Thus a 1 amp 12 V nominal solar panel will power the motor at 2.5 Amps.

Mechanical Specifications

  • Weight:
    • less than 1 lb.
  • Size:
    • 4.5" X 2.1" X 2.1" resembling a junction box with mounting feet
  • Operating Temperature:
    • -40 to 70 deg. C
  • Humidity:
    • 90 % non-condensing
  •  

Note: To allow for changing the fuse the cover can be removed. To make the unit waterproof, apply a small amount of silicon around the unit's lid.

Connections

  • Power: PV and Load 6 inch # 16 AWG flying leads
  • Input: Red = PV +, Black = PV -
  • Output: White = Pump +, Blue = Pump -
  • Signal: float switch, 12/24 V select
  • 6 inch # 24 flying leads yellow: connect to PV - = OFF for float switch operation
  • 6 inch # 24 flying leads purple: connect to PV - = 24 V operation disconnected = 12 V operation
  • 6 inch # 24 flying leads orange: connect to PV - = 30 V output limit disconnected = 15 V output limit
Application Notes:
  1. This Pump Power Tracker(TM) is quite capable of putting out over 15 amps into a stalled load even from a single 30 watt 4.5 amp panel. It is recommended that a fuse or overtemperature switch matched to your pump motor be incorporated in the system to protect your pump or motor.
  2. Float switch operation draws microamps of current, i.e. small wire gauge, allowing long distance runs between float switches / holding tanks, and PV / pump driver without the need to string long lines of heavy gauge wire.
  3. Unit is a true 10 amp unit, all necessary derating already accounted for. Unit is capable of 8 amp operation with normal derating practices.
  4. As with all electronics, it is recommended the unit not be mounted in direct sunshine.
  5. Solar panel or energy limited input only.

Note: In the interest of continuous product improvement, specifications subject to change without notice.

Order Model No:

PPT 12/24-10
PPT 12/24-10 MXX for different motor voltage where XX is the max. motor voltage

Downloadable PDF Documentation:

PPT 12/24-10 PDF File must be viewed with Adobe Acrobat Reader

Special Shipping Note:
All Solar Converter Products are behind in production. These items are usually shipped directly from the manufacturer in Canada. They cannot be shipped by any expedited methods such as UPS Blue or Red. They will generally be shipped via Canadian Express Mail which avoids import brokerage fees of $50-$60. Lead time on these products may be up to 4-6 weeks depending on their production. This is true of all Solar Converters products with the exception of the battery desulphator (item code SORBD-2) that we stock in our warehouse. If you want Solar Converters products to be shipped by normal Canadian Post, but would prefer to have the rest of your order to be shipped by a faster method, please write this information in your order's notes during checkout.

Solar Converters Inc


Click here for BBB Business Review ASE NESEA Member
Paypal Visa MasterCard Amex Discover
McAfee SECURE sites help keep you safe from identity theft, credit card fraud, spyware, spam, viruses and online scams