Environmental Solar Systems SunMate Wall Mount Package

• Is the house 2x4 or 2x6 construction? The vents are 11" standard length but can be cut to better fit the house.
• Is the house new construction? Is the panel going to be mounted to the outside sheathing (plywood or boards)?
• What type of siding does the house have?
• Will the SunMate be mounted on top of the siding?

Environmental Solar Systems
SunMate™
(Hot Air Solar Panel)
Wall Mount Package

Made in the U.S.A.!

The SunMate™ Solar Panel is the ideal choice for homeowners that want an environmentally friendly, low-cost air heating option. The SunMate™ pulls cool air from your home, channels it through the absorber plate where it’s warmed by energy from the sun, then circulates it back into your home. A built-in thermostat automatically turns on the fan when the absorber plate reaches 110° F and shuts the fan off when the plate reaches 90°F.

What sets the SunMate™ apart from other solar panels is the design. One-piece construction produces a streamlined appearance that doesn’t detract from your home’s appearance. Heavy-duty, stainless steel and aluminum components provide quality construction that assures long life and virtually no maintenance.

The SunMate™ by Environmental Solar System is efficient and affordable. A single panel heats up to 750 square feet. Double-sealed solar glass eliminates air infiltration and water leaks. Polyisocyanurate insulation results in extremely low heat loss and an 8.5 Watt fan operates for just pennies per day. You can run the SunMate completely without AC power by connecting the fan to a 20 Watt solar module!

The SunMate™ is installed vertically and mounted on the side of your home or building. The design accommodates 2” x 4” or 2” x 6” construction. Parallel installation allows you to integrate multiple panels for larger heating areas.

Package Includes:

• 1 SunMate solar air heater
• 1 Wall Mount Kit

Features

• High efficiency and reliability
• Easy to install: wide variety of simple installations
• Can be used for fresh air intake for tight houses
• Brushless 100 CFM, 12VDC - 8.5 Watt fan
• Automatic thermostat automatically turns the fan on and off (see installation instructions below)
• 10-Year Warranty on Solar Panel
• One Year Warranty on fan, thermostat and transformer

SunMate solar panel wall mounting kit

• SMOS-1 Bottom mounting bracket
• SMOS-2 Top mounting bracket
• SMOS-3 Top panel flashing
• SMOS-4 Fan with air duct and finger guard
• SMOS-5 Return air duct with finger guard and air filter
• SMOS-6 Interior solar panel thermostat
• SMOS-7 Interior wall thermostat
• SMOS-8 Old work electrical work box
• SMOS-9 120 Volt AC to 12 Volt DC 1 amp wall transformer
• SMOS-10 - 5’ long thermostat wire
• SMOS-11 Stainless steel screws and hardware

Thermostat Installation Instructions

In the fan tube you will find a blue wire nut. Remove that wire nut and separate the wires (two wires). The fan tube has a hole where you can pass the thermostat wire through to the inside of the tube. Connect the red and the white wire of the thermostat to those two wires and put the wire nuts back onto the wires. Note there is another wire nut provide in the kit. Using the same bay between the studs run the wire up the wall. Remove the front cover off the thermostat and you will see two terminals on the top of the thermostat that are marked W and RH. Connect the red and the white thermostat wires to those terminals. (Note) Poke a hole approximately 5 feet up the wall and run a snake down the wall; then attach the thermostat wire to the snake and pull the thermostat wire up the wall.