Steca Solled
Energy Saving 12 Volt Lamp
12VDC Light Emitting Diode Bulbs

In these LED lamps for direct current we combine pricing and high quality. The service life is therefore considerably higher than those of any other kind of illumination. Extremely important for all solar and battery systems is the low energy consumption compared to other light sources with the same brightness. Such energy saving loads pay off very well in solar systems. The costs in your solar system depend considerably on the average consumption and the service life of the single loads. The luminous efficiency of LED-lamps is three times higher than those of halogen lamps. The screwing socket of the LED lamp can be screwed into every standard lamp socket. Our LED lamp enable you to design your leisure and residential areas individually.

Features

• Install in any conventional incandesent socket
• Compact attractive design
• Power is less than 1 Watt
• Long life time service
• Luminous efficacy is much better than bulb or halogen lamp
• Each SolLED lamp is a compound unit with multiple individual LED's per lamp
  • White .7W - 10 small LED's
  • Yellow .7W - 8 small LED's
  • White .35W - 4 small LED's
  • Yellow .35W - 5 small LED's

Important Hints For Operation:

1. OperationVoltage
   12V-types: 10.5V - 15V direct voltage
2. Polarity
   When you install your lighting unit please make sure that the minus pole is connected to the thread and the plus pole to the middle contact of the socket.When the poles are inverted, the SOLLEDLED lamp does not work. In the case of wrong polarity there is no damage.
3. Ambient Temperature
   Following temperature range is admissible for all SOLLED LED lamps:
   -40°C up to 70°C
4. Mechanical Features
   Please do not try to pull the lamp out of the socket, as possible claims for replacement cannot be considered.

Precaution

• Suitable for dimming and electronic switches
• Do not use on emergency exit fixtures or lights
• Never disassemble or modify the lamp
• Install and remove lamp from fixture by grasping plastic base
• Never use in 230 or 110VAC fixture
• Unstable for applications where over 15VDC