Xantrex Dc175 175A, 125Vdc Disconnect W/Encl

Add-Ons

Xantrex Dcbb Negative/Ground Bonding Block

Cd15 15A DC Breaker

Cd60 60A DC Breaker

Cd75 75A DC Breaker

Trace / Xantrex The DC250 and DC175 Meet code with Trace's new DC disconnect/overcurrent module.

Now it's easier to meet National Electric Code requirements with a Trace DC175 or 250. These modules are designed to link with Trace SW and DR series inverter systems.

Battery disconnect: An easy way to isolate inverter and battery

• Meets National Electrical Code requirement for "means of disconnection."
• No exposed "hot" terminals
• Doesn't need ring terminal lugs
Overcurrent protection: DC circuit breakers UL listed for up to 125VDC
• Extremely low voltage drop (less than most fuses or current shunts)
• Rated for interrupting high fault current (up to 25,00 amps at 65 VDC)
• Easy to reset
• No exposed "hot" terminals
Room for expansion
• Optional second main breaker accommodates dual inverter systems
• Second breaker can be field installed
• Space allows for DC current shunts
Optional bonding block simplifies wiring and grounding
• Bonds negative conductor to grounding system at single point
• Lugs to terminate four 4/0, two #1/0, two #2 and four #4 cables
Four Auxiliary breaker positions
• Optional 15-amp DC breaker for small DC loads or equipment room light
• Optional 60-amp DC-rated breaker for PV array disconnect, charge controller, etc.
• UL listed for DC systems up to 125 VDC
• Rated for interrupting high fault current, up to 25,000 amps at 65 VDC
• Easily accessible #10-32 stud terminals

 

Note: Products are listed by UL and/or ETL to UL specifications
 

© Trace Engineering