MNE175ST E-Panel Gray Steel Chassis 175 Amp Breaker for 1 FX

Add-Ons

Outback 3000W FX3048T 48VDC/120VAC Inverter

Outback 2000W FX2012T 12VDC/120VAC Inverter

Outback 2500W FX2524T 24VDC Inverter

Outback 3000W GTFX3048 48VDC,120VAC Inverter

Outback 3600W GVFX3648 48VDC,120VAC Inverter

Outback 2500W GTFX2524 24VDC/120VAC Inverter

Midnite Solar E-Panel for Outback Inverters The Midnite Solar E-Panel saves time money and space. It is a compact, affordable panel for mounting a single inverter. But it is also modular for mounting multiple inverters.

E-panel without an inverter	One E-panel shown with Outback Inverter (Inverter not included, just shown as an example)
Modular Design Midnite Solar has designed a panel that is not only compact, but modular in that it can be stacked either horizontally or vertically. Unlike other Power Systems that tend to take up a large amount of horizontal space, by using a vertically stacked pair of E-Panels you can have two inverters in about the same space as a broom closet.
Two Horizontally Stacked E-panels (Inverters and charge controllers not included)	Two Vertically Stacked E-panels (Inverters and charge controllers not included)

Easy Installation
Another plus of the E-Panel is that with the unique hinged door, you mount the inverter to the door while it lays flat on your bench and then simply hang it on the panel which has already been mounted to the wall. You simply lift it up, insert tab "A" into slot "B" and you are done. There are no fasteners required at this point, so no need to try to balance an inverter and remember where you left your extra set of hands. It's no longer necessary to call the local crane company nor three of your friends to help you with the install. One person can do it quite nicely, as shown in the four consecutive steps below.

Easy Access to Wiring Concerned that such a compact panel will not provide sufficient access to the wiring? Once again, the hinged door makes it easy. Simply swing it out of the way and you have unobstructed access to all wiring.

Features

• Small size compared to existing products
• Pre-wired to save time, money and complexity. All field wiring connections clearly labeled
• White powder coated aluminum or standard gray powder coated steel
• Easily expands to accommodate up to four inverters with no interconnecting conduit
• Six slots per unit for 13 mm wide Din Rail mount breakers; PV, Wind, Hydro and AC distribution or three 19mm wide breakers
• 500 amp 50 mV shunt for battery status monitoring systems
• Pre-wired 50 amp 240 VAC inverter AC bypass switch
• Pre-wired 50 amp 240 VAC AC input disconnect
• Mounting hardware for inverter and charge controller
• Snap in plastic conduit for AC, Mate and RTS wires
• Mounting brackets for hanging E-panel on wall
• Heavy duty 175 amp AC distribution block
• ETL listed to UL and CSA standards
• Right hand hinged door to mount inverter (left hand available on request)
• Knock outs for AC and DC conduits
• Charge control bracket (CCB)
• Cut outs for two North American style GFCI outlets
• DC inverter battery breaker
• Internal inverter DC cables
• Bus bars for Battery Plus, Battery Minus and Ground

System Options (Click Model Number for more Information)