Tom's posts

Posted by Tom on May 16, 2002 12:55 pm

#31 -  Renewable Energy > Technical Discussion: Other > Re: differential contoller
try www.grainger.com
 

Posted by Tom on May 3, 2002 10:20 am

#32 -  Renewable Energy > Wanted > Re: Looking for solar-powered pool heater...
Using a car thermostat rated at 160 F will begin to open around 100 F anyway. The 160 Rating is when it is fully open.
 

Posted by Tom on May 3, 2002 10:15 am

#33 -  Renewable Energy > Wanted > Re: Looking for small round PV cells for hobby project
try your local Radio Shack or electronics store.
 

Posted by Tom on May 3, 2002 10:13 am

#34 -  Renewable Energy > Wanted > Re: low-powered pump
how small a pump do you need, eg, flow rate. Radio shack carries some small dc submersible pumps for hobbies. Or go to the website for American Science and Surplus. They have a lot of gizmos.
 

Posted by Tom on May 3, 2002 10:10 am

#35 -  Renewable Energy > For Sale > Re: mounting system
there are no set rules for mounting. Do you have room on the ground? You can mount them on other parts of your roof as long as you direct and angle them correctly.
 

Posted by Tom on May 3, 2002 10:07 am

#36 -  Renewable Energy > For Sale > Re: LOOKING FOR SMALL ROUND PV CELLS FOR HOBBY PROJECT
try radio shack or equivalent
 

Posted by Tom on Apr 25, 2002 12:31 pm

#37 -  Renewable Energy > Technical Discussion: Other > Re: remote internet bridge
Nick, first you will have to use some 6 volt batteries. The most common is what is called a golf cart battery and can be found most anywhere. You would put 3 of these in series to get your 18 volts. Then if you want 3 days storage:

18 volts x 1amp = 18watts
x 24 hrs x 3    = 1296 watt hrs
/ 18 volts      = 72 amp hrs   or 24 amp hrs/day

So you would have to get batteries with a rating of 80-100 amp hrs. Two 50W panels, at 18 volts, getting 10 hrs of sun a day, will get you
27 amp hrs/day.  

 

Posted by Tom on Apr 25, 2002 12:11 pm

#38 -  Renewable Energy > RE General Discussion > Re: wind heat
Bruce, Alan has the right idea. A diversion load is what is mainly used. A bank of resistors, usually mounted on a heat sink, can serve as this load and will produce heat that can be harnessed using fans, as can an electrical water heater elements which must be submerged in order not to overheat and fry out. But as Alan said a diversion to a useful load is best, as long as it is something that constantly has a draw of current and is properly switched once the diversion load is available.
 

Posted by Tom on Apr 25, 2002 12:00 pm

#39 -  Renewable Energy > RE General Discussion > Re: Questions installing a Solar panel system?
You should be using the power from the system directly without tying into the power company, whom you are trying to avoid in the first place. All you need is a properly sized inverter to change from DC/AC.
 

Disclaimer and Disclosure

The Alternative Energy Store, Inc reserves the right, within its sole discretion, to refuse or delete any posting or portion thereof, or terminate or block the access to this forum.

The opinions and statements posted on this forum are the opinions and statements of the person posting same, and do not constitute the opinion or act of the Alternative Energy Store, Inc (AltE). The Alternative Energy Store, Inc does not endorse or subscribe to any particular posting. No posting shall be construed as the act or opinion of the Alternative Energy Store, Inc.

Click here for BBB Business Review

McAfee SECURE sites help keep you safe from identity theft, credit card fraud, spyware, spam, viruses and online scams
Desktop Website | Mobile Website

Share

Click on an icon to share! If you don't see the method you want, hover over the orange "+".

Feedback

What can we do to help you?

Please enter a summary
Sorry, the copyright must be in the template.
Please notify this forum's administrator that this site is using an ILLEGAL copy of SMF!
Copyright removed!!