Mini Wind gen question

Posted by Max Schulte on September 16, 2009, 07:51:00 PM

Re: Mini Wind gen question (Reply #5)
Yes I have the 200w version but only 3 blade. I have had it go thru 2 storms that the weathercube said 50mph gust. But I did have the tail turned 20 degrees.Do you know what speed you had blade failure at?I have had no problems yet that were major only a single rust spot.But I had the inside track and got the body and tail powder coated. I have put it into service now after 3 mo of testing. When I finally put it in its permanate spot the wind stops blowing.LOL Its been 3 wks...
 

Posted by David Day on September 16, 2009, 08:26:48 PM

Re: Mini Wind gen question (Reply #6)
The root cause was a clearance issue of blade to tower. I think the wind was in the 20's with gusts to 30. I really like the little turbine but wish it did not have the cogging effect of getting it to turn. Don with WindGen is right, when it turns, it charges. I have since put up a PrestoWind PMA with the 48" 3-blade kit. It starts turning at around 3-4 mph but low voltage 4-7 volts but when we do get good wind it cranks it out. I had thought about coupling the little generator to the pma and piggyback off the big blades??? Good luck,
David
 

Posted by Max Schulte on October 31, 2009, 01:18:24 PM

Re: Mini Wind gen question (Reply #7)
Last night a blade hit the tower but we had some high gusts.I wonder if I am going to get into a balance problem? lost 1\2 in of blade. Does anyone know what size PCV pipe they make these blades out of?
 

Posted by David Day on October 31, 2009, 08:44:49 PM

Re: Mini Wind gen question (Reply #8)
Max, I have already replaced the blades on mine, this is the response I got from Don with usawindgen:

just thin 4" sewer pipe will work fine

You can take the damaged blade and another blade off and run it with 4 blades if need be.

David
 

Posted by Max Schulte on November 08, 2009, 08:48:32 PM

Re: Mini Wind gen question (Reply #9)
David
 I know I am not in a good wind area but I have a question? Did you ever put an Amp gauge on your USAwind unit. I got the 200W unit. The best wind I get around here I have squeezed 3 amp burst with 1 amp average. Dont get me wrong I am not complaining I just want to compare.
 
Forums | Design by Scratchmedia | Development by SMF.
© 2001-2005, Lewis Media. All Rights Reserved.

Disclaimer and Disclosure

The Alternative Energy Store, Inc reserves the right, within its sole discretion, to refuse or delete any posting or portion thereof, or terminate or block the access to this forum.

The opinions and statements posted on this forum are the opinions and statements of the person posting same, and do not constitute the opinion or act of the Alternative Energy Store, Inc (AltE). The Alternative Energy Store, Inc does not endorse or subscribe to any particular posting. No posting shall be construed as the act or opinion of the Alternative Energy Store, Inc.

Call us for solar panel system design help.
877-878-4060

Se habla Español
 

top members