Inverter to Subpanel wiring – hot/hot

Posted by Ken Hall on April 03, 2009, 09:48:56 PM

Re: Inverter to Subpanel wiring – hot/hot (Reply #5)
They may not say that it is a full voltage scheme. But you can ask that question. Or ask if it is NEC (national electric code) approved.  Half voltage schemes are not NEC approved.  Almost any full sine wave inverter will be full voltage.

Another thing you can ask about or look for in the US is the UL approval. If it is UL458, it is definately a half voltage inverter.

Don't even consider trying to get a 220V half voltage scheme and wire it up.

 

Posted by Bently Harris on April 03, 2009, 10:50:00 PM

Re: Inverter to Subpanel wiring – hot/hot (Reply #6)
Thanks Ken.
 
Forums | Design by Scratchmedia | Development by SMF.
© 2001-2005, Lewis Media. All Rights Reserved.

Disclaimer and Disclosure

The Alternative Energy Store, Inc reserves the right, within its sole discretion, to refuse or delete any posting or portion thereof, or terminate or block the access to this forum.

The opinions and statements posted on this forum are the opinions and statements of the person posting same, and do not constitute the opinion or act of the Alternative Energy Store, Inc (AltE). The Alternative Energy Store, Inc does not endorse or subscribe to any particular posting. No posting shall be construed as the act or opinion of the Alternative Energy Store, Inc.

Call us for solar panel system design help.
877-878-4060

Se habla Español

latest posts

more »
 

top members